Help! Wingstays

[tj]

I have fitted the front but I cannot see how to align the rears?

I have an NB with ABS which I am removing so the wingstays will fit, but as you can see from the image the wingstay hits the abs mount, if I fit it flush to the abs mount is there going to be enough clearance?

Do I need to shave the abs mount?

(30mm spacer is fitted)

[p2tav]

Jun 10, 2018 9:29:00 GMT tj said:

I have fitted the front but I cannot see how to align the rears?

I have an NB with ABS which I am removing so the wingstays will fit, but as you can see from the image the wingstay hits the abs mount, if I fit it flush to the abs mount is there going to be enough clearance?

Do I need to shave the abs mount?

(30mm spacer is fitted)

hi tj

can you take a picture with the wheel off so I can see how you have mounted the wheel stays front bolt. when you are not using abs it normally fits at the back of the abs mount and you drill a hole in the abs mount block between where the bolts go in to hold abs sensor. 

[Stiggy]

Please see the build guide. You will need the calpiers fitting to place the wing stay properly. The ABS ring will need cracking off with a hammer and chisel to gain clearance. Then it will all line up for you to drill the block that the ABS sensor was mounted on.

[tj]

Thanks for your help, yes, I can see the problem. I had read the guide, but I’d put the wingstay on the outside rather than the inside, should be able to get it to fit now.