Track day safety upgrades

[colin]

I finished my build about a year ago and have been loving taking it to the track. I’m planing a couple upgrades before my next track day. I ordered an electrical cut off switch, a fire suppression system, and some roll bar padding. If anyone has advice for installing these or other items I should add to my list I’d be happy for the advice!

[kiwicanfly]

What are you using as a harness?

I was using a four point in my Rocket but changed to six point, loads better.

My four point would sit above my hips and the lap belts were difficult to tighten as they were pull down.

The pull up six point sits and stays where it should.

[colin]

Yah, I’ve got 6 point harnesses, seat back braces, and a HANS device already.

[colin]

Got them installed. Hope never to have to use them! I went with gauge 1 wire for the starter because I had read somewhere thats what I should use, but clearly it was way bigger than needed. If I were to do it again I'd order 2 or 3 gauge at the most. Also I think the ESS brand fire suppression system is well designed, but the instructions that come with it are super vague. They had a slightly better version on their website, but still it was a lot of figuring out on my own.