|
|
Post by hutchey on Dec 16, 2019 15:16:39 GMT
Hi, what's the best way to fit these? Where to drill the holes in the sides so as to get them to sit on the brackets, clear the tyres and still pass IVA?
|
|
russhowell
Full
2004 1.8 Euphonic Mk 2.5 Arctic Blue 75,000Miles
Posts: 141
|
Post by russhowell on Dec 17, 2019 15:35:41 GMT
i had the realisation that if the brackets clear the tyres, then of course the wings will as well, as they sit on top of the brackets.
The holes need to almost flush with the top, so when the brackets slide in, they are nice and flush against the inside top, to give you most 'purchase' or surface area contact. Once you have slid them on, you should be able to lift them slightly, jam in loads of Tiger Seal, and then squish them back down with a weight on top.
Before fitting rears, i tiger sealed some of the wire from the lights on the rear wings....then when fitting to the brackets, the rest of the cable was pushed into the tiger seal, along the bracket and out through a slightly bigger hole with rear bracket arm.
Im sure there is a picture in my post... if not i'll add one
|
|
