|
|
Post by kev80 on Jun 6, 2019 13:39:52 GMT
Can the two tubular sections to the front of the rear sub frame be removed? I recall seeing somewhere they are not used in the build (and I can't see any mounting points) but thought best to check!  |
|
russhowell
Full
2004 1.8 Euphonic Mk 2.5 Arctic Blue 75,000Miles
Posts: 141
|
Post by russhowell on Jun 6, 2019 13:47:59 GMT
I cant see your picture on my work system however I have documented this in my build and also recall seeing a picture in the build guide. I think you need to keep the smaller square frame and cut off the longer two tubular tubes...
|
|
|
|
Post by kev80 on Jun 6, 2019 13:52:14 GMT
That was what I thought, cheers!
|
|
russhowell
Full
2004 1.8 Euphonic Mk 2.5 Arctic Blue 75,000Miles
Posts: 141
|
Post by russhowell on Jun 6, 2019 13:52:27 GMT
i can see your pic now. You can actually cut off most of it and keep approx 3 inches which you can flatten down and bolt to two tabs that now exist on the frame from MEV.
This is also documented in the build guide.
Not sure if its worth the effort.
|
|
|
|
Post by kev80 on Jun 6, 2019 14:09:10 GMT
i can see your pic now. You can actually cut off most of it and keep approx 3 inches which you can flatten down and bolt to two tabs that now exist on the frame from MEV. This is also documented in the build guide. Not sure if its worth the effort. It was your build thread I had seen it in! Thanks again. Grinder will get another outing when I've got the last few bolts out. |
|
